Acid Catalyst Pigments, Primers & Enamels

Acid Catalyst Pigments, Primers & Enamels

Always stir well and check shade and sheen before use.

It is important that the right amount of catalyst is added.

Coverage
Approximately (mixed) 7 square metres per litre.

Low formaldehyde
Specially formulated to have low Formaldehyde emission. Equivalent to E1 standard - 80gms/sq. metre film drying for 14 days at 20°C and 65% RH

Pot life
24 - 36 hours. Catalysed lacquer left overnight should be adjusted for viscosity and mixed 1:1 with freshly catalysed lacquer prior to use.

Application
Standard products are for application by Conventional, HVLP or Air assisted Airless spray methods.
Normally, two or more coats of the same material are applied, the exception being the full matt lacquer where we recommend a basecoat of higher sheen material is used to maintain clarity of finish.

Air pressure: 40 - 50 psi
Fluid Pressure: 8 - 10 psi

A minimum shop temperature of 15°C is required.

Drying
Touch dry: 15-20 mins
Sanding/re-coating: 60-90 mins
These times may be reduced by forced drying. At temperatures below 15°C and high humidity, drying times will be extended and film formation endangered.
Packing: Overnight minimum.

Thinners
Acid Catalyst Fast Dry Thinners: 00 164 7290

Cleaning fluid Dual Thinners: 00 802 5432 (Use only for cleaning).

Stains
Non-fade Ground Stain: Suitable
Waterstain: Suitable
Lightfast: Suitable
NB. Stains must be dry before continuing with finishing system.